AutoFlame

Autoflame is an advanced Combustion Management System, which uses micro modulation to control damper drives to 0.1 of a degree (angular travel). The Autoflame system can also use closed loop tuning (exhaust gases) to obtain correct combustion. The Autoflame Combustion Management System is available upon supply of a complete package system or as a retrofit to an existing application. Each system is individually engineered to suit client requirements.

Click on pictures to see detailed brochures or:

Click for detailed Mini Mk5 Evolution MM brochure

MM Fuel/Air Ratio Control
4 servo channels
2 variable speed channels
4 fuel programmes
Precise Target Set-point Control
Burner Control
UV Flame Safeguard
Gas Valve Proving
Gas, Oil and Air Pressure Supervision
Flue Gas Re-circulation Management
Infrared Port

Click for detailed MK6 Evolution MM brochure

Mk6 Evolution MM Module

Factory fitted and installed or retrofitted at a later date
Steam flow recording
TDS sampling
Water feed pump control

Mini Mk6 MM Module

Water Level Controller for Mk6 Evolution

MM Fuel/Air Ratio Control
4 servo channels
4 fuel programmes
UV Flame Safeguard
Burner Control
Precise Target Set-point Control
Infrared Port

Mini Mk5 MM Module

MM Fuel/Air Ratio Control
3 servo channels
3 fuel programmes
Precise Target Set-point Control
Infrared Port

EGA Sampling Unit

Continuous measurement (and display) of flue gas
Full diagnostics
Low maintenance
Low cost
Automatic calibration
Analogue and digital output signals
O² CO² and CO sensors as standard
6 configurable 4-20ma outputs

EGA Sampling Probes

0-400°C operating range
Ceramic version 0-1600°C
Particulate and acid bubble pot filters available for harsh environments

Additional Sensors

NO, NO² and/or SO² sensors factory fitted and installed

DTI System Package

DTI. Module
Win PC DTI + CEMS remote monitoring and control software
DTI-PC communication lead

DTI. Data Transfer Interface
Integrate up to 10 MM/EGA modules, 10 stand-alone EGAs, 10 Analogue I/Os and 10 Digital I/Os. Interface with a Modbus or Metasys compatible B.M.S. or a P.C. running Autoflame's Win PC DTI software.

Win PC DTI software including CEMS PC-based monitoring and control of the MM/EGA system. Extensive information and control functions for MM, EGA & I/O units. Continuous emissions monitoring and data logging. Define and manage alarm codes. Connect directly or dial into a DTI remotely via modem

Digital I/O Module

Interface third party boiler house equipment to the MM/EGA. system via the D.T.I.
16 line voltage inputs
8 volt free contacts

Analogue I/O Module

Interface third party boiler house equipment to the MM/EGA. system via the DTI.
6 4-20mA inputs
6 4-20mA outputs

Shown below is a complete system build-up. Each installation is specifically engineered as a variation of this to suit individual client requirements.